Shinya
11-11-2005, 05:14 AM
I think I found a cheap and great combination here. Adhesive and remover for under $10.
This is not as strong as the Hollister Medical Adhesive 7730, but you will get a day of wear out it easy enough.
I have done this more then once, my skin don't seem to react to the Elmers or Googone. Test your skin first, you might find it won't work for you.
I apply them just this way for a longer bond, spray forms and place on chest as quik as you can. The Elmers says permanet bond if applied inside of 15 seconds. No worries of that, the oils in your skin will brake it down over a few hours, but not to the level of looseing one. You will want to hold them on for a couple of minutes, then use a old tight fitting bra to let them set up really well (about 10 minutes).
If you had to you can peal them off right away if need be. A lot easier then the Hollister adhesive. If your still bugging about getting them off fast use paper towels wetted with the Googone.
Clean up is much easier then the Hollister. Sillycone forms clean up great. Rezidue comes off of skin with paper towel wetted with Googone.
Too thoughs that give it a try, test test test, before you go fot it. As I don't want to catch hell from someone that gets a skin rash or worse. I would say to use only on the plastic membraine sillycone forms.
My venture, your gain.
Now get out there and let them bounce.
This is not as strong as the Hollister Medical Adhesive 7730, but you will get a day of wear out it easy enough.
I have done this more then once, my skin don't seem to react to the Elmers or Googone. Test your skin first, you might find it won't work for you.
I apply them just this way for a longer bond, spray forms and place on chest as quik as you can. The Elmers says permanet bond if applied inside of 15 seconds. No worries of that, the oils in your skin will brake it down over a few hours, but not to the level of looseing one. You will want to hold them on for a couple of minutes, then use a old tight fitting bra to let them set up really well (about 10 minutes).
If you had to you can peal them off right away if need be. A lot easier then the Hollister adhesive. If your still bugging about getting them off fast use paper towels wetted with the Googone.
Clean up is much easier then the Hollister. Sillycone forms clean up great. Rezidue comes off of skin with paper towel wetted with Googone.
Too thoughs that give it a try, test test test, before you go fot it. As I don't want to catch hell from someone that gets a skin rash or worse. I would say to use only on the plastic membraine sillycone forms.
My venture, your gain.
Now get out there and let them bounce.